RJ1612 twin head laser machine

Moderators: HPC, Daven

Post Reply
woodturningbypaul
Posts: 17
Joined: Mon Dec 19, 2011 1:01 pm
Contact:
Contact woodturningbypaul

RJ1612 twin head laser machine

Post by woodturningbypaul »

HI all

I am looking for some information, I have just got an RJ1612 twin head laser machine running Laserscript 5.3. one tube is 120w and 1 60w. I can cut with the 120w tube but not do a light engrave. Normally I would reduce power and increase the speed, but on this new machine the power doesn’t seem to make any difference. Also does anyone know how to switch between the two tubes on laserscript ie one engraving and one cutting

Thanks for any help

Paul
Top
Spooky
Posts: 1291
Joined: Mon Apr 26, 2010 10:17 pm
Contact:
Contact Spooky

Re: RJ1612 twin head laser machine

Post by Spooky »

Resolved
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Dave@OpticalPower.co.uk
Top
Post Reply

Return to “Help or advice required please”

Who is online

Users browsing this forum: No registered users and 11 guests