Laserscript user forum

I've just had exactly the same problem as Mat.
I've not actually used my laser cutter all over winter and my workshop's been littered with electronics and other junk, but when I came to fire it up this evening, my host PC died.
I plugged my (Windows 7 32-bit) laptop in, installed the same software Mat mentioned in his post, and got the same error when I tried to manually import/merge the .reg files. So I can get NarlyDraw running on my laptop (with the dongle plugged in) but I can't get a response from the laser cutter - every time I try to engrave or jog the cutting head, I get "logic data port error" or something like that.

Is there anywhere we can get drivers for Windows 7 (32-bit for me, but others might need 64-bit?). Or does anyone have any they wouldn't mind sharing?
Thanks!
Chris

Hi Chris,
Windows 7 32-bit uses the same drivers as XP - there are no drivers for 64-bit.

Mat got his working off another PC so put it down to his laptop. I'm sure I have heard about this problem before with some laptops but can't remember where I saw it.

If you can try it on another 32bit pc and see what happens.

Cheers

Dave

Hi i need some help to, i've got a new computer as my old one broke at the weekend but its windows 7 where can i get the driver, newly draw works fine.
thanks
Kayleigh

I used the same disk that came with the laser - Windows 7 needs to be 32bit though

Best

Dave

Hi

I am also having problems installing my LS3020 drivers - can install newly draw fine but when I try to install the device it wont recognise it would someone be able to send me a copy of the drivers or assist.

Mike