Hi,
Is Polycarbonate ok for laser cutting?. I have a large excess sheet that I would like to use for some DIY projects.
cheers
Sam
Is Polycarbonate ok for laser cutting?
Re: Is Polycarbonate ok for laser cutting?
This post may help - http://www.laserscript.co.uk/phpBB3/viewtopic.php?t=609
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Is Polycarbonate ok for laser cutting?
Looks like it could be a bit of hassle. Thanks for the link Daven.
Re: Is Polycarbonate ok for laser cutting?
No problems 
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 2 guests