My tube was arcing, at the positive connection
I have fixed it with silicon sealant, will it of done any damage to the PSU or tube?
Cutting is a bit less efficent than a couple of days ago, but my tube is getting old so it could just be that
Thanks
Tube arcing
-
SillyJokes
- Posts: 26
- Joined: Fri Nov 15, 2013 2:18 pm
- Contact:
Tube arcing
Owner of a new LS3040 PRO
Re: Tube arcing
Chances are - no! Not if it had not been for too long.
Had the insulation broken down?
Best
Dave
Had the insulation broken down?
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
-
SillyJokes
- Posts: 26
- Joined: Fri Nov 15, 2013 2:18 pm
- Contact:
Re: Tube arcing
Yes, at the anode.Daven wrote:Had the insulation broken down?
Owner of a new LS3040 PRO
Who is online
Users browsing this forum: No registered users and 14 guests