Photograv

Moderators: HPC, Daven

Post Reply
CNCBob
Posts: 14
Joined: Fri Dec 28, 2012 12:59 pm
Location: Watford
Contact:
Contact CNCBob

Photograv

Post by CNCBob »

I have just got my copy of Photograv, in the machine selection there is no mention of the Laserscript, does anyone
Know what the nearest machine to a LS 6840
or what setting I need.

Many thanks

Bob.
LS6840. Lasercut. Aspire Vectric
Top
Spooky
Posts: 1291
Joined: Mon Apr 26, 2010 10:17 pm
Contact:
Contact Spooky

Re: Photograv

Post by Spooky »

afaik Bob there is no direct output to the LS series, I think you need to save the pic as a BMP and import from there.

I haven't used PG for some time though so things may have changed.

best wishes

Dave
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Dave@OpticalPower.co.uk
Top
CNCBob
Posts: 14
Joined: Fri Dec 28, 2012 12:59 pm
Location: Watford
Contact:
Contact CNCBob

Re: Photograv

Post by CNCBob »

Spooky wrote:afaik Bob there is no direct output to the LS series, I think you need to save the pic as a BMP and import from there.

I haven't used PG for some time though so things may have changed.

best wishes

Dave
Thanks Dave,

It wasn't so much the output to the laser, more on the actual laser setting in Photograv, apparently the nearest settings
are the Rabbit HX6090 for the LS6840

Bob
LS6840. Lasercut. Aspire Vectric
Top
Post Reply

Return to “General Discussion”

Who is online

Users browsing this forum: No registered users and 17 guests