Got to make another one but I'll swapout the hardboard with MDF this time, as that was horribble stuff to cut and left crud all over the rails and surface of the laser bed.
Enjoy !
Peter
Solder Iron Tidy/Storage
-
Pedro_Hernandez
- Posts: 184
- Joined: Thu Dec 09, 2010 8:54 pm
- Location: Hertfordshire
- Contact:
Solder Iron Tidy/Storage
Just though i'd share this with you, I made it last year I think for the K4 Electronic' groups.
Got to make another one but I'll swapout the hardboard with MDF this time, as that was horribble stuff to cut and left crud all over the rails and surface of the laser bed.
Enjoy !
Peter
Got to make another one but I'll swapout the hardboard with MDF this time, as that was horribble stuff to cut and left crud all over the rails and surface of the laser bed.
Enjoy !
Peter
HPC1290 User HPC 3020 Owner
Re: Solder Iron Tidy/Storage
Nice 
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Solder Iron Tidy/Storage
Excellent job Peter.
Tweakie.
Tweakie.
-
Pedro_Hernandez
- Posts: 184
- Joined: Thu Dec 09, 2010 8:54 pm
- Location: Hertfordshire
- Contact:
Re: Solder Iron Tidy/Storage
Cheer's guy's for the encouraging compliments, I've got to make another one now as the K4 Electronics class has doubled.
This time I will use MDF, that hardboard leaves a horrible mess !.
Peter
This time I will use MDF, that hardboard leaves a horrible mess !.
Peter
HPC1290 User HPC 3020 Owner
Who is online
Users browsing this forum: No registered users and 17 guests