Laserscript user forum

Posted: **Wed Dec 16, 2020 12:40 pm**

Hello everyone, hope you're all safe and well

Got a question about engraving.

I'd like to engrave some text on acrylic. I'm using Autocad 2007 for the text and saving it as a dxf but when I import into Laserscript 6.1 all I'm getting is the text outline.

I've tried both hatching and polyline line width but neither seem to be working.

Thanks in advance

James

Posted: **Wed Dec 16, 2020 3:23 pm**

If you set the object to engrave it should engrave as long is it is a single PLine - so 1st line turns on engrave next one in turns off and repeat.

If you are using normal annotate text I think you can Pexplode - it needs to be a joined polyline.

Best
Dave

Posted: **Wed Dec 16, 2020 3:48 pm**

Thanks for the reply

I'll give it a go tomorrow and see what happens

cheers

James

Laserscript user forum

Hello From London (and a bit of help)

Hello From London (and a bit of help)

Re: Hello From London (and a bit of help)

Re: Hello From London (and a bit of help)