Power setting issues on "Engrave"

ollyholford · Post by **ollyholford** » Thu Nov 27, 2014 8:37 pm

Hello, I bought an LS3020 pro back in June and I'm having trouble altering the power setting when in engrave. The speed is set to 200 and the power 18. I want to change the power down but when I select the engrave mode, I change it to 15, press enter but the value still stays at 18 in the top right corner. Can anybody help? Also the software crashes a lot which is frustrating. It says not responding, and I have to force the program to shut and start again. Please help.

Post by **Daven** » Thu Nov 27, 2014 8:50 pm

What operating system are you using?

Is it Lasercut or Newlydraw software?

Best
Dave

Spooky · Post by **Spooky** » Fri Nov 28, 2014 4:33 pm

You need to press OK not Enter, enter applies to the cancel button

cheers

Dave

ollyholford · Post by **ollyholford** » Fri Nov 28, 2014 5:18 pm

I'm on windows 7 pro and using the laser cut 5. 3. When I alter the power setting on cut mode it changes with enter. I'll try pressing ok and see what happens. Thanks for your help

ollyholford · Post by **ollyholford** » Fri Nov 28, 2014 5:32 pm

Problem solved, on Engrave the value changes if you press OK, not enter, but on cut the value changes when you press enter. Thanks for your help

Spooky · Post by **Spooky** » Fri Nov 28, 2014 8:48 pm

No problem

Laserscript user forum

Power setting issues on "Engrave"

Power setting issues on "Engrave"

Re: Power setting issues on "Engrave"

Re: Power setting issues on "Engrave"

Re: Power setting issues on "Engrave"

Re: Power setting issues on "Engrave"

Re: Power setting issues on "Engrave"

Who is online