Just joined the forum after buying my laser from HPC.
I'd like to publicly thank the team at HPC for sorting out my software issues. Rebooted the flash memory then reinstalled the software, and alls "tickaty boo" as they say.
Looking forward to learning lots and enjoying my new 'toy' .
Hello from Sheffield
Hello from Sheffield
LS3020LSCT, Lasercut 5.3, Win7 netbook
a whole lot of time with only a modicum of talent
a whole lot of time with only a modicum of talent
Re: Hello from Sheffield
Hiya Jim,
best wishes
Dave
best wishes
Dave
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Dave@OpticalPower.co.uk
Dave@OpticalPower.co.uk
Re: Hello from Sheffield
Hi Jim,
Welcome along
Best
Dave
Welcome along
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 0 guests