Laserscript user forum

Hi again,
Engraving and using this forum is most interesting. Here is a quick one. Before I try it, does anyone know the out come if I was to engrave a picture on a bottle of Champagne.
Cheers
Trev

Watch the power setting trev, Champagne can cavitate and pop the cork if you over cook it

I'd be looking around 50 speed and 10 power for a starting point working down on speed to say 20 before upping the power if the results aren't good enough

Keep your slideways nice and clean when working with glass, it errodes from the surface when engraved and if it mixes with oil can make a nice effective grinding paste best to keep the air blow on all the time and vac out the machine on a very regular basis

best wishes

Dave