Laserscript user forum

Hi All

just noticed tonight the laser is cutting twice round each item, i have looked at the forum and it was surgested that it was the import, so i produced a square in lasercut 5.3 only which cut twice. Dont think i have changed anything. What would cause this.

thanks

Paul

Daft question - on the panel on the laser - is Pieces set to 1?

Best

Dave

Another thing I just thought of - last column on the cut/engrave speed/power settings there is 'Times' - any chance this has been set to 2?

Dave

yep

never noticed that before

thanks

Paul

sorry was replying to your question about the control panel

both the panel and the last column are both set to one

Paul

Can't think what else at the moment then. Will have a think

Dave

If you draw a single line does it do that twice too?

sorted !!

I have rechecked all the setting, the first piece I cut tonight I set the power and the speed and i guess tabbed onto the overlap which was set to 72, which i had not noticed. I reset that back to .1.

thanks for all your help dave much appreciated.

Paul

No worries - glad you sorted it

Best
Dave