Page 1 of 1
Aztec engrave on weird card
Posted: Thu Jan 05, 2012 10:59 am
by Pedro_Hernandez
I dug this out recently on a job that I did a while back.
The stock card has a weird rubberised texture and originaly was given it to do a cut into but it left a oily residue that stained the edges.
By accident I discovereed that a fast enough cut and low speed would leave a white mark and aan engrave was even better.
I'll post the make and code when I can find it and post it here.
Regards
Peter
Re: Aztec engrave on weird card
Posted: Fri Jan 06, 2012 10:54 am
by tweakie
That's nice Pete, what diameter is it please ??
Tweakie.
Re: Aztec engrave on weird card
Posted: Fri Jan 06, 2012 11:30 am
by Pedro_Hernandez
tweakie wrote:That's nice Pete, what diameter is it please ??
Tweakie.
aprox 80mm
Regrds
Peter
Re: Aztec engrave on weird card
Posted: Fri Jan 06, 2012 11:39 am
by tweakie
Thanks. If you do come across the dxf or code, I would like to try that.
Tweakie.
Re: Aztec engrave on weird card
Posted: Fri Jan 06, 2012 11:48 am
by Pedro_Hernandez
tweakie wrote:Thanks. If you do come across the dxf or code, I would like to try that.
Tweakie.
I've got the dxf, but its a huge file for some reason at around 7mb.
Peter
Re: Aztec engrave on weird card
Posted: Fri Jan 06, 2012 12:15 pm
by tweakie
Perhaps not then.
Thanks for looking Peter.
Tweakie.
Re: Aztec engrave on weird card
Posted: Fri Jan 06, 2012 12:50 pm
by Pedro_Hernandez
tweakie wrote:Perhaps not then.
Thanks for looking Peter.
Tweakie.
I've zipped it down to about 900kb, wont let me upload it though as its over 256kb.
PM me an email address and I'll email it as a zipped.
Peter
Re: Aztec engrave on weird card
Posted: Fri Mar 02, 2012 11:20 am
by Pedro_Hernandez
Pedro_Hernandez wrote:tweakie wrote:That's nice Pete, what diameter is it please ??
Tweakie.
aprox 80mm
Regrds
Peter
Just found the file, its 75mm