wood veneer
wood veneer
is it possible to engrave only on wood veneer ?
Re: wood veneer
Hi Paul,
Yes it is - just need to get the power right - another problem is keeping it flat so tape and weights will help.
Cheers
Dave
Yes it is - just need to get the power right - another problem is keeping it flat so tape and weights will help.
Cheers
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 0 guests