Laserscript user forum

Hi

Has anyone tips on engraving on glass, seting etc?

thanks, Mandy

Hiya Mandy,

Power 8 to 12
Speed 200 to 300

and see what happens

Too much power or too low a speed will result in heat cracking the glass.
Start low and work up is about the best way to go

best wishes

Dave

Thanks, Dave, I'll give it a try.

Hi Mandy,
We use an engrave speed of 400 and a power of 35-40 % but we always cover the glass with wet paper as this works like a heatsink.
Give it a try and you will see the difference.