Hi
Has anyone tips on engraving on glass, seting etc?
thanks, Mandy
glass engraving
Re: glass engraving
Hiya Mandy,
Power 8 to 12
Speed 200 to 300
and see what happens
Too much power or too low a speed will result in heat cracking the glass.
Start low and work up is about the best way to go
best wishes
Dave
Power 8 to 12
Speed 200 to 300
and see what happens
Too much power or too low a speed will result in heat cracking the glass.
Start low and work up is about the best way to go
best wishes
Dave
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Dave@OpticalPower.co.uk
Dave@OpticalPower.co.uk
Re: glass engraving
Thanks, Dave, I'll give it a try.
Re: glass engraving
Hi Mandy,
We use an engrave speed of 400 and a power of 35-40 % but we always cover the glass with wet paper as this works like a heatsink.
Give it a try and you will see the difference.
We use an engrave speed of 400 and a power of 35-40 % but we always cover the glass with wet paper as this works like a heatsink.
Give it a try and you will see the difference.
Who is online
Users browsing this forum: No registered users and 3 guests