is there anywhere I can get advanced training on my cutter? learning any shortcuts/new techniques and how to fix problems without having to call out engineers each time? just general knowledge on how the cutter works so I can problem solve a bit better on my own?
There is so much I want to do with my machine but haven't a clue how and get sick of searching for tutorials with no info!
thanks
advanced training on 6040
-
- Posts: 10
- Joined: Sun May 03, 2015 2:56 pm
- Contact:
Re: advanced training on 6040
Where are you?
You may find someone who is willing to help for a beer or two
Best
Dave
You may find someone who is willing to help for a beer or two
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
-
- Posts: 10
- Joined: Sun May 03, 2015 2:56 pm
- Contact:
Re: advanced training on 6040
i am in dinnington near sheffield! i know my alignment is off at the moment but i dont know how to change it! last time i messed with it i messed it up!!
Re: advanced training on 6040
You are not too far from HPC - why not call and ask if you could go to them for some training?
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 0 guests