Aztec engrave on weird card

[Pedro_Hernandez]

I dug this out recently on a job that I did a while back.

The stock card has a weird rubberised texture and originaly was given it to do a cut into but it left a oily residue that stained the edges.

By accident I discovereed that a fast enough cut and low speed would leave a white mark and aan engrave was even better.

I'll post the make and code when I can find it and post it here.



Regards

Peter

[tweakie]

That's nice Pete, what diameter is it please ??

Tweakie.

[Pedro_Hernandez]

That's nice Pete, what diameter is it please ??

Tweakie.

aprox 80mm

Regrds

Peter

[tweakie]

Thanks. If you do come across the dxf or code, I would like to try that.

Tweakie.

[Pedro_Hernandez]

Thanks. If you do come across the dxf or code, I would like to try that.

Tweakie.

I've got the dxf, but its a huge file for some reason at around 7mb.

Peter

[tweakie]

Perhaps not then.

Thanks for looking Peter.

Tweakie.

[Pedro_Hernandez]

Perhaps not then.

Thanks for looking Peter.

Tweakie.

I've zipped it down to about 900kb, wont let me upload it though as its over 256kb.

PM me an email address and I'll email it as a zipped.

Peter

[Pedro_Hernandez]

That's nice Pete, what diameter is it please ??

Tweakie.

aprox 80mm

Regrds

Peter

Just found the file, its 75mm