3020 controller board help

Moderators: HPC, Daven

Post Reply
TheMillsta
Posts: 1
Joined: Thu Mar 18, 2021 10:53 pm
Contact:

3020 controller board help

Post by TheMillsta »

Hi All
I've purchased an old 3020 machine which runs software called Newly draw which isn't the best. I've decided to upgrade the controller to the XL4 however the pinouts are slightly different and I was wondering if anyone has the schematic/pin out information of the attached picture.
The old board has a separate 2 wire laser out at J4 (top right corner) black wire to power supply and yellow to what looks like a transformer box.
The new board has a single wire laser out housed within the power connector so I'm trying find out which wire to use.

I hope that makes sense, any advice would be appreciated, also I'm not overly electronically minded :-/
Attachments
XL4
XL4
Post Reply

Who is online

Users browsing this forum: Ahrefs [Bot], Google [Bot] and 7 guests