Hello & help !

Moderators: HPC, Daven

Post Reply
steve1564
Posts: 7
Joined: Sun Dec 18, 2016 1:14 pm
Contact:

Hello & help !

Post by steve1564 »

Hi Everyone... and its a warm evening in North Somerset

A couple of years ago i purchased an LS1290 from a local firm that was closing -

Last week i decided to get the machine up & running - I HAVE NO CLUE WHAT I'M DOING !!!!
(ok maybe that was a bit harsh, i know about some stuff, but not enough about leetro control)

So there will shortly follow a whole load of silly questions & problems.....

Stay tuned its gonna be fun !

(Here's a teaser) - Should i be able to XY move the laser from power up ? - (no pc connected)


Thanks in advance.

Steve
LS1290 - Leetro 6515 & PAD03 - Lasercut 5.3
"I wonder if we do this, will it f**k it up...... Oh Yea, It did!"
Daven
Posts: 1632
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Hello & help !

Post by Daven »

Hi Steve,
Welcome ;)

Yes you should be able to use the arrow buttons on the keypad - press 'Esc' then the arrow button ;)

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
steve1564
Posts: 7
Joined: Sun Dec 18, 2016 1:14 pm
Contact:

Re: Hello & help !

Post by steve1564 »

Thanks Dave,

I cant ! ...

Gonna move this to the help & advise board

Steve
LS1290 - Leetro 6515 & PAD03 - Lasercut 5.3
"I wonder if we do this, will it f**k it up...... Oh Yea, It did!"
Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest