Ls6090 axis misbehaving

Moderators: HPC, Daven

Post Reply
Steve78
Posts: 6
Joined: Sun May 24, 2020 5:51 pm
Contact:

Ls6090 axis misbehaving

Post by Steve78 » Mon Apr 26, 2021 12:54 pm

Hello all

I have a fault that has developed on the axis of my ls6090 that I desperately need help with... pics attached

In short, the laser appears to be firing fine, but both the x and y axis seem to be jumping sporadically... sometimes it cuts fine, but much of the time it's producing a serrated cut and even turning what should be smooth diagonal lines into what resembles a set of stairs... I've considered that the belts may need tightening or replacing but a) I've no idea how to check them, and b) it seems suspicious to me that they should both be on the fritz at the same time

As I said, it doesn't do it on every line, but often enough that it's ruining almost every piece of work that I'm trying to do. Any help and advice greatly appreciated.. my business is relying heavily on a working laser cutter and I'm totally stuck while this is going on. Regards, steve
Attachments
20210426_124516.jpg
Serrated edge should be continuous line
20210426_124551.jpg
Stepping line that should be smooth

Daven
Posts: 1624
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Ls6090 axis misbehaving

Post by Daven » Mon Apr 26, 2021 5:48 pm

Give HPC a call - it will be quicker than trying to troubleshoot here ;)

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest