Communication broken due to timeout

Please read before posting to the forum

Moderators: HPC, Daven

Post Reply
Rick
Posts: 30
Joined: Tue Jun 17, 2014 7:40 pm
Contact:

Communication broken due to timeout

Post by Rick »

Can anyone throw any light on a problem that has recently started to occur on my LS3020 please: I regularly get an error message that the connection is broken due to time-out. This involves switching off the machine and waiting for it to reset. This can happen if it has been idle for 5 minutes and other times not happen all morning then after maybe a half hour break.
Restating Laserscript doesn't resolve the issue - only closing and opening the laser.
Any suggestions would be most appreciated, Rick
Daven
Posts: 1632
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Communication broken due to timeout

Post by Daven »

USB port has power saving on or USB cable a bit dodgy I would guess ;)

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Rick
Posts: 30
Joined: Tue Jun 17, 2014 7:40 pm
Contact:

Re: Communication broken due to timeout

Post by Rick »

Hi! Thanks for that - I think it is a dodgy USB port - cheers!
craftybubble
Posts: 10
Joined: Sun May 03, 2015 2:56 pm
Contact:

Re: Communication broken due to timeout

Post by craftybubble »

I get this problem if I turn my computer on before the laser machine is turned on. if I make sure the laser cutter is on first... I don't get the problem. if the laser cutter is switched off and then back on and the computer is just left on throughout, it also needs restarting.
Post Reply

Who is online

Users browsing this forum: No registered users and 3 guests