LASERABLE ENGRAVING LAMINATE

Please read before posting to the forum

Moderators: HPC, Daven

Post Reply
Rick
Posts: 30
Joined: Tue Jun 17, 2014 7:40 pm
Contact:

LASERABLE ENGRAVING LAMINATE

Post by Rick »

I am about to use 1.5MM BLACK / WHITE engraving laminate for the first time and am unsure what the best speed/power settings should be on my LS3020 Pro. Can anyone advise me before I start wasting too much material please?
Regards, Richard
Daven
Posts: 1632
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: LASERABLE ENGRAVING LAMINATE

Post by Daven »

I can't remember but a highish scan gap (300dpi+) helps and remove the protective film and use transfer paper.

Cheers
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Post Reply

Who is online

Users browsing this forum: No registered users and 12 guests