Search found 1603 matches

by Daven
Wed Jun 09, 2021 11:59 am
Forum: Help or advice required please
Topic: CW4000 user manual
Replies: 1
Views: 86

Re: CW4000 user manual

Sorry - I don't have one - maybe email HPC?
Best
Dave
by Daven
Sat May 15, 2021 7:56 am
Forum: Help or advice required please
Topic: LaserCut 5.3
Replies: 3
Views: 146

Re: LaserCut 5.3

Hi - yes it should be part of the install disk - have you got it to transfer to the machine (if successful the machine will beep).

It may be worth calling HPC and getting the correct version for the card you have as well in case it is not the original disk.

Best
Dave
by Daven
Thu May 13, 2021 10:16 am
Forum: Login and say Hello
Topic: Hello and Help
Replies: 3
Views: 216

Re: Hello and Help

No problems and welcome ;)
Best
Dave
by Daven
Thu May 13, 2021 8:36 am
Forum: Login and say Hello
Topic: Hello and Help
Replies: 3
Views: 216

Re: Hello and Help

Hi Zoe - I do not use Mac's or lightburn so can't help but I bet if you called HPC someone will help you out ;)

Best
Dave
by Daven
Wed May 12, 2021 4:40 pm
Forum: Help or advice required please
Topic: LaserCut 5.3
Replies: 3
Views: 146

Re: LaserCut 5.3

file, Machine Options, worktable :)
by Daven
Fri May 07, 2021 8:54 am
Forum: Help or advice required please
Topic: bed raise/lower
Replies: 1
Views: 169

Re: bed raise/lower

Yep that is the same on mine - if you press datum it will re-set back to the top on it's own.
The speed is slow though - should be quicker than that - make sure the belt isn't slipping.

Best
Dave
by Daven
Mon Apr 26, 2021 5:48 pm
Forum: General Discussion
Topic: Ls6090 axis misbehaving
Replies: 1
Views: 260

Re: Ls6090 axis misbehaving

Give HPC a call - it will be quicker than trying to troubleshoot here ;)

Best
Dave
by Daven
Mon Apr 12, 2021 9:07 am
Forum: Help or advice required please
Topic: Engraving speeds and power on HPC 6090 pro
Replies: 3
Views: 301

Re: Engraving speeds and power on HPC 6090 pro

No problems - DPI = dots per inch - so resolution.

In Lasercut 5.3 - double click on the speed power and set scan gap there ;)

Best
Dave
by Daven
Mon Apr 12, 2021 7:52 am
Forum: Help or advice required please
Topic: Engraving speeds and power on HPC 6090 pro
Replies: 3
Views: 301

Re: Engraving speeds and power on HPC 6090 pro

More speed = less darker/deep Less power = same as above Less DPI (Scan gap) = same as above So increase speed and reduce power and check scan gap settings. Too much speed is not good so check manual or give HPC a call, I normally keep to less than 400 mm/s Scan gap setting can be found here http://...
by Daven
Sat Apr 10, 2021 7:04 pm
Forum: Help or advice required please
Topic: Blocked Output coupler
Replies: 7
Views: 656

Re: Blocked Output coupler

I use chlorine granules you can buy for hot tubs at DIY sheds - just a teaspoon full seems to help every few months.
Best
Dave