Page 1 of 1
Test Button Query
Posted: Sat Jun 28, 2014 10:23 am
by PeterB
Usually before I run a job I press the "TEST" button to make sure my material is in the correct place, sometimes when pressing the TEST button nothing happens. Is this usual ?
I use a LaserScript 600x900 60watt
Peter
Re: Test Button Query
Posted: Sat Jun 28, 2014 11:17 am
by Daven
Yes - it depends on the mode it is in - I tend to hit the esc key before anything else
Re: Test Button Query
Posted: Sat Jun 28, 2014 1:04 pm
by Tom
Hi Peter
If it still has the time on the screen it will not test.
Just press ESC
Tom
Re: Test Button Query
Posted: Sat Jun 28, 2014 8:21 pm
by PeterB
Ok, thanks.
Re: Test Button Query
Posted: Sat Jul 05, 2014 1:26 pm
by PeterB
Test button works every time now, many thanks