We have recently purchased a LS6840 with 60w upgrade and although we are just testing the water with it, we can't seem to get rid of the burn marks when cutting card.
The best results we've had is at 90 speed 20 power,buy its still straining the outside edges yellow. I know from HPC FB page they can cut through card/paper no problem, any one offer us any advice?
Many Thanks
cutting card help
Re: cutting card help
Up the air assist, as low power and high speed as you can to cut and use card with low chalk content if possible 
Cheers
Dave
Cheers
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 6 guests