Reassemble in reverse order - make sure lens is replaced correct way up.
Hope this is of use
Dave
Using two LS3060's and an ex 3020 user Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
On my one you don’t have to remove the tube from the cone, if you loosen the cone there is enough slack to get it off.
Very important point about the orientation of the lens, it works both ways but has 20% more power if fitted in the correct orientation, i.e. with the curve surface facing up.
I could possiby do the same on mine Mike but while I was there I thought it was just as easy to remove the tube and give the nozzle a good clean.
Orientation of all parts is worth noting - for anyone who hasn't seen my thread in general disscusion where I put the mirror in the head back round the wrong way
Dave
Using two LS3060's and an ex 3020 user Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
