Hello and Help
Posted: Thu May 13, 2021 7:24 am
Hello everyone
I’m zoe from Scotland and I have just purchased my first laser cutter which I am very excited about however I am struggling to connect it to my Mac computer .
Has anyone else had success connecting lightburn on a Mac to there laserscript? I have tried usb, manual set up and using Ethernet following this tutorial https://forum.lightburnsoftware.com/t/h ... ernet/7672 but the IP address (inet) doesn’t seem to show up properly on my terminal so I can’t really go past the first stage.
Has anyone else had this problem and managed to overcome it or even used any other software to connect to your laser on a Mac?
Thanks in advance
Zoe
I’m zoe from Scotland and I have just purchased my first laser cutter which I am very excited about however I am struggling to connect it to my Mac computer .
Has anyone else had success connecting lightburn on a Mac to there laserscript? I have tried usb, manual set up and using Ethernet following this tutorial https://forum.lightburnsoftware.com/t/h ... ernet/7672 but the IP address (inet) doesn’t seem to show up properly on my terminal so I can’t really go past the first stage.
Has anyone else had this problem and managed to overcome it or even used any other software to connect to your laser on a Mac?
Thanks in advance
Zoe