Hello everyone, hope you're all safe and well
Got a question about engraving.
I'd like to engrave some text on acrylic. I'm using Autocad 2007 for the text and saving it as a dxf but when I import into Laserscript 6.1 all I'm getting is the text outline.
I've tried both hatching and polyline line width but neither seem to be working.
Thanks in advance
James
Hello From London (and a bit of help)
Re: Hello From London (and a bit of help)
If you set the object to engrave it should engrave as long is it is a single PLine - so 1st line turns on engrave next one in turns off and repeat.
If you are using normal annotate text I think you can Pexplode - it needs to be a joined polyline.
Best
Dave
If you are using normal annotate text I think you can Pexplode - it needs to be a joined polyline.
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Hello From London (and a bit of help)
Thanks for the reply
I'll give it a go tomorrow and see what happens
cheers
James
I'll give it a go tomorrow and see what happens
cheers
James
Who is online
Users browsing this forum: No registered users and 1 guest