Hello
New to this and the laser machining.
Great bit of kit just a quick question ours has a black temp sensor out the back where do I place this sensor do I just hang it so senses room temp or does it go in the water to get water temperature when machine operating.
Sorry didn’t see this in instructions
Temp sensor LS3040
-
- Posts: 4
- Joined: Sun May 17, 2020 7:42 pm
- Contact:
Re: Temp sensor LS3040
That's new! I should imagine the water as that is more important - anything over around 21 degrees and there is a chance the tube will overheat.
I keep mine at 13 degrees which seems to work well.
Best
Dave
I keep mine at 13 degrees which seems to work well.
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
-
- Posts: 4
- Joined: Sun May 17, 2020 7:42 pm
- Contact:
Re: Temp sensor LS3040
Hi Dave
Thanks for reply much appreciated
Thanks for reply much appreciated
Who is online
Users browsing this forum: No registered users and 0 guests