Hi Everyone... and its a warm evening in North Somerset
A couple of years ago i purchased an LS1290 from a local firm that was closing -
Last week i decided to get the machine up & running - I HAVE NO CLUE WHAT I'M DOING !!!!
(ok maybe that was a bit harsh, i know about some stuff, but not enough about leetro control)
So there will shortly follow a whole load of silly questions & problems.....
Stay tuned its gonna be fun !
(Here's a teaser) - Should i be able to XY move the laser from power up ? - (no pc connected)
Thanks in advance.
Steve
Hello & help !
Hello & help !
LS1290 - Leetro 6515 & PAD03 - Lasercut 5.3
"I wonder if we do this, will it f**k it up...... Oh Yea, It did!"
"I wonder if we do this, will it f**k it up...... Oh Yea, It did!"
Re: Hello & help !
Hi Steve,
Welcome
Yes you should be able to use the arrow buttons on the keypad - press 'Esc' then the arrow button
Best
Dave
Welcome
Yes you should be able to use the arrow buttons on the keypad - press 'Esc' then the arrow button
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Hello & help !
Thanks Dave,
I cant ! ...
Gonna move this to the help & advise board
Steve
I cant ! ...
Gonna move this to the help & advise board
Steve
LS1290 - Leetro 6515 & PAD03 - Lasercut 5.3
"I wonder if we do this, will it f**k it up...... Oh Yea, It did!"
"I wonder if we do this, will it f**k it up...... Oh Yea, It did!"
Who is online
Users browsing this forum: No registered users and 0 guests