Laserscript user forum

Hi all,
As usual I have a rush job over the weekend....then I have a probem.

I am working on a job that has engraving and low power cutting, I had no problem with this before, the engraving is fine but the laser
has stopped firing when cutting, also when you press the Laser test button nothing happens.

LS6840 40w

Any ideas please

Many thanks

Bob

Check the power output on the machine panel menu including 2nd level down.

Best
Dave

Many thanks Dave, that was the problem although I’m not sure how it changed.

Regards

Bob

Easy done when adjusting the table height

Best
Dave