Laserscript user forum

Do anyboy here cut card , i got a wedding coming up in the family and got to cut card / paper ect any info will be great thanks

Hi ooper,

I sell cards through Etsy that are both engraved and cut. I just use Kraft card in A6.

I have a LS3040 with a 60 Watt Tube.

Settings I use are:

Engraving - 500% Speed, 20% Power

Cutting - 10% Speed, 15% Power.

Hope this helps!

Thanks bud , could you tell me the settings you use for cutting 3 mm ply please

Give Manila a try, Soft Card is a bit hit and miss when you Cut it and gives off a lot of Soot. Manila is a harder type of Finish and Cuts really well.

You'll get some good results using it.

Dynamode.