Laserscript user forum

Hi guys
Just put a new computer to my machine and i cant get the thing to talk to it. Lasercut installs fine and works but get the timed out message. I have checked the device drivers and I can't get the Ez-usb fx2 to install. Never had any problems before and it's been really straightforward. Can anyone point me in the right direction to solving this?
Many thanks in advance
Richard

Hi
EZ-USB is the machine with out the drivers
Right click and update drivers

Tom

Hi tom
What do I right click on. I've done every type of driver update and it comes up with can't install drivers
Many thanks Richard

Hi
You should be able to right click on the ez usb and then direct in to the disk
If It's windows 10 then there is something in F.A.Q’s & Tutorials about it i think

Tom

I'll give it another go and see if it works.
Many thanks for the advice
Richard

is Tom HPC ?

if so, or not, can you put in your 'sig' ?

Would It make a difference if i was

I guess not then