I cut 1.5mm hips around the 25/40 mark if I remember right but I have a small silent compressor so can up the airflow. There is a larger HAILEA pump which will help if a compressor is not feasible.
I have a file set up with 8 rectangles (around 10 by 8mm) and underneath similar sizes circles. Set each set of shapes to a different layer (so the first on the left rectangle and circle set to red, next one's blue......), set each layer the same power but increase the speed in increments of say 5 (I use 2 now). Cut this test sheet in the furthest corner away from the start point and you will have a guide to the best settings without using lots of material.
If when you cut a full sheet and parts do not cut it can be the bed not being level or alignment issues.
Best
Dave
Probably some typical newby questions.....
Re: Probably some typical newby questions.....
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: Ahrefs [Bot] and 1 guest