3020 Intermittent cutting

Moderators: HPC, Daven

Post Reply
ChipW66
Posts: 3
Joined: Thu Dec 16, 2021 4:46 pm
Contact:

3020 Intermittent cutting

Post by ChipW66 »

Hi,
I replaced the tube and power supply approx 18 months ago and it has done approx 20 hours work since. Lately,when cutting, I find that it will often lose power and not fully cut through a part of the design. Today it was cutting out a single 50mm design and part of it was fine and part wasn't.
The bed is level and checked for the correct height.
Surely the tube and / or power supply don't need replacing again yet???
Any help would be greatly appreciated
Regards
Chris
Daven
Posts: 1635
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: 3020 Intermittent cutting

Post by Daven »

Hi Chris.
If the tube is overheating it can stop cutting until it cools down - can you explain a bit more when it stops and if it starts again?
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
ChipW66
Posts: 3
Joined: Thu Dec 16, 2021 4:46 pm
Contact:

Re: 3020 Intermittent cutting

Post by ChipW66 »

Hi Dave,
Thanks very much for your reply, really appreciated.
I wanted to do a couple of test pieces before I replied.
It seems that it is the opposite, it is the first couple of designs which don't cut properly and then it's ok. It's as if it needs to warm up first.
Regards
Chris
Daven
Posts: 1635
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: 3020 Intermittent cutting

Post by Daven »

Check the connections to the tube to make sure there is no arching.

Depending on how the tube has been used and looked after it may only last a short time if you are unlucky.

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
ChipW66
Posts: 3
Joined: Thu Dec 16, 2021 4:46 pm
Contact:

Re: 3020 Intermittent cutting

Post by ChipW66 »

OK, I'll check the connections.
Thanks Dave, much appreciated
Post Reply

Who is online

Users browsing this forum: Ahrefs [Bot] and 1 guest