Using an HPC3020, been cutting fine until today, tried cutting and no power. Checked the alignment, this is the pattern on the 3 mirrors...
Instead of a dot I'm getting a circle...
Anyone got any suggestions??
3020 laser issue
3020 laser issue
Hi
Using an HPC3020, been cutting fine until today, tried cutting and no power. Checked the alignment, this is the pattern on the 3 mirrors...
Instead of a dot I'm getting a circle...
Anyone got any suggestions??
Using an HPC3020, been cutting fine until today, tried cutting and no power. Checked the alignment, this is the pattern on the 3 mirrors...
Instead of a dot I'm getting a circle...
Anyone got any suggestions??
Re: 3020 laser issue
I had this once and it turned to be the tube.
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 1 guest