I’m zoe from Scotland and I have just purchased my first laser cutter which I am very excited about however I am struggling to connect it to my Mac computer .
Has anyone else had success connecting lightburn on a Mac to there laserscript? I have tried usb, manual set up and using Ethernet following this tutorial https://forum.lightburnsoftware.com/t/h ... ernet/7672 but the IP address (inet) doesn’t seem to show up properly on my terminal so I can’t really go past the first stage.
Has anyone else had this problem and managed to overcome it or even used any other software to connect to your laser on a Mac?
Hi Zoe - I do not use Mac's or lightburn so can't help but I bet if you called HPC someone will help you out
Best
Dave
Using two LS3060's and an ex 3020 user Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Using two LS3060's and an ex 3020 user Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC