Hello, I'm hoping you may be able to help me with my 8 year old co2 900/600 laser. We have just fitted a new bulb and can line up the first two mirrors fine but the 3rd mirror goes really out of line when moving the dolly from front to back. Have measured the distance from the back of the machine to the front of the bar that the dolly sits on and there is a 10mm difference at each side. When you measure at the front there is no difference.
Could this be the cause of the problem and any ideas on how to rectify?
Many thanks, Ian
Mirror allignment
Re: Mirror allignment
Thanks anyway folks, spoken to Chris and going to give a good clean and tighten one of the belts. Hopefully that will work
Re: Mirror allignment
Chris is the man
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 1 guest