Good afternoon from Portsmouth.
Good afternoon from Portsmouth.
Hi everyone, I've been having an issue recently when cutting. The laser seems to have different start and finish points, even on simple cuts. It'll cut round the shape but then continue cutting round for approx 50mm. Any ideas how to resolve please?
Re: Good afternoon from Portsmouth.
Check the overlap option (double click on the layer where you set the speed and power) - default is 0.05000 - it may have been set to 50.
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Good afternoon from Portsmouth.
Hi Dave, thanks for that. I've checked and can see where I've gone wrong. I accidentally changed the overlap when changing the power. That's too many late nights in the mancave lol
Re: Good afternoon from Portsmouth.
LOL - yep been there a few times
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 1 guest