Temp sensor LS3040

Moderators: HPC, Daven

Post Reply
anthony1980
Posts: 4
Joined: Sun May 17, 2020 7:42 pm
Contact:

Temp sensor LS3040

Post by anthony1980 » Tue May 19, 2020 7:47 pm

Hello

New to this and the laser machining.
Great bit of kit just a quick question ours has a black temp sensor out the back where do I place this sensor do I just hang it so senses room temp or does it go in the water to get water temperature when machine operating.
Sorry didn’t see this in instructions

Daven
Posts: 1533
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Temp sensor LS3040

Post by Daven » Wed May 20, 2020 7:51 am

That's new! I should imagine the water as that is more important - anything over around 21 degrees and there is a chance the tube will overheat.

I keep mine at 13 degrees which seems to work well.

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

anthony1980
Posts: 4
Joined: Sun May 17, 2020 7:42 pm
Contact:

Re: Temp sensor LS3040

Post by anthony1980 » Wed May 20, 2020 9:34 pm

Hi Dave

Thanks for reply much appreciated

Post Reply

Who is online

Users browsing this forum: No registered users and 9 guests