Hi all,
As usual I have a rush job over the weekend....then I have a probem.
I am working on a job that has engraving and low power cutting, I had no problem with this before, the engraving is fine but the laser
has stopped firing when cutting, also when you press the Laser test button nothing happens.
LS6840 40w
Any ideas please
Many thanks
Bob
Rush job...problem
Rush job...problem
LS6840. Lasercut. Aspire Vectric
Re: Rush job...problem
Check the power output on the machine panel menu including 2nd level down.
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Rush job...problem
Many thanks Dave, that was the problem although I’m not sure how it changed.
Regards
Bob
Regards
Bob
LS6840. Lasercut. Aspire Vectric
Re: Rush job...problem
Easy done when adjusting the table height 
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: Bing [Bot] and 0 guests