I am about to use 1.5MM BLACK / WHITE engraving laminate for the first time and am unsure what the best speed/power settings should be on my LS3020 Pro. Can anyone advise me before I start wasting too much material please?
Regards, Richard
LASERABLE ENGRAVING LAMINATE
Re: LASERABLE ENGRAVING LAMINATE
I can't remember but a highish scan gap (300dpi+) helps and remove the protective film and use transfer paper.
Cheers
Dave
Cheers
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 0 guests