PART FILE MISSING WHEN I BRING FROM COREL DRAW TO LASERSCRIPT?

Moderators: HPC, Daven

Post Reply
Wibn
Posts: 4
Joined: Wed Apr 17, 2019 10:45 pm
Contact:
Contact Wibn

PART FILE MISSING WHEN I BRING FROM COREL DRAW TO LASERSCRIPT?

Post by Wibn »

Hi,
Any help or advice appreciated. When I save a file on corel draw to a plt and open it on laserscript part seem to be missing.
It is on hairline setting in corel draw.
Im a bit lost.
LS1290 Wooden It Be Nice Ireland 🍀
Top
Daven
Posts: 1632
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:
Contact Daven

Re: PART FILE MISSING WHEN I BRING FROM COREL DRAW TO LASERSCRIPT?

Post by Daven »

Sorry - I can't help as I do not use Corel - anyone else?

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Top
Post Reply

Return to “Help or advice required please”

Who is online

Users browsing this forum: No registered users and 2 guests