PART FILE MISSING WHEN I BRING FROM COREL DRAW TO LASERSCRIPT?

Moderators: HPC, Daven

Post Reply
Wibn
Posts: 4
Joined: Wed Apr 17, 2019 10:45 pm
Contact:

PART FILE MISSING WHEN I BRING FROM COREL DRAW TO LASERSCRIPT?

Post by Wibn » Sat Oct 24, 2020 11:24 am

Hi,
Any help or advice appreciated. When I save a file on corel draw to a plt and open it on laserscript part seem to be missing.
It is on hairline setting in corel draw.
Im a bit lost.
LS1290 Wooden It Be Nice Ireland 🍀

Daven
Posts: 1569
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: PART FILE MISSING WHEN I BRING FROM COREL DRAW TO LASERSCRIPT?

Post by Daven » Sat Oct 24, 2020 12:19 pm

Sorry - I can't help as I do not use Corel - anyone else?

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

Post Reply

Who is online

Users browsing this forum: No registered users and 12 guests