Hi, I have owned a 6090 laser for many years and was running it on windows vista since the beginning, I have just upgraded my pc to a Windows 10 but it will not communicate with the laser.
I have been into the device manager and tried to update the divers many times using the files on the disk and files I have on my pc but no joy, the Ez USB Fx2 is showingup as other device in the device manager.
I am wondering as I bought the laser approximately 13 years ago would the drivers on my disk work with windows 10 or do I need a newer software/ drivers cause I have tried everything and usually can figure these things out quite easily but this has really got me stumped??
Thanks
Ian
EZ-usb fx2
Re: EZ-usb fx2
Hi Ian - give HPC a call - they may be able to help depending on the board you have.
There are Win 10 drivers for Laserscript 5.3 but not sure for earlier versions.
They would need to know if it is 32 or 64bit Version of Win 10.
Best
Dave
There are Win 10 drivers for Laserscript 5.3 but not sure for earlier versions.
They would need to know if it is 32 or 64bit Version of Win 10.
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: No registered users and 1 guest