Newlydraw dongle advice

Moderators: HPC, Daven

Post Reply
unravelled
Posts: 12
Joined: Tue Nov 23, 2010 7:25 pm
Location: Brockley, SE London
Contact:

Newlydraw dongle advice

Post by unravelled » Mon Jul 27, 2020 11:52 am

My machine is a LS3020 running Newlydraw software on a win98 pc. It has been out of use for some time for a repair, and now it is ready to test, I seem to have mislaid the dongle for the software. I need to work out how to proceed.
The first thought is whether there is a market in secondhand dongles, or are they not interchangeable? What I am hoping for is that someone has a dongle I can borrow, which will allow me to test the machine. If it is working I can think about buying one.
My second alternative is to ask whether there is any other, dongle free, software now available, fsuitable for the 3020. Preferably free or with a free trial period so that I can test the machine without too much outlay.
Of course if it doesn't work I may be considering a new laser cutter...

Thanks

Dave

Daven
Posts: 1550
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: Newlydraw dongle advice

Post by Daven » Mon Jul 27, 2020 12:34 pm

Hi Dave,
Call HPC - they may still have spares.

No other software will work as far as I am aware as the software, dongle and machine are all linked to the controller board.

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

Post Reply

Who is online

Users browsing this forum: No registered users and 14 guests