LASERCUT 5.3

Moderators: HPC, Daven

Post Reply
brydonuk
Posts: 22
Joined: Wed Oct 09, 2019 10:38 pm
Contact:

LASERCUT 5.3

Post by brydonuk »

Hi a little help with the software if possible please.

In Lasercut when choosing either "Cut or engrave" there is another one called "GradeEngrave" when the engineer installed the machine and did the training he didn't tell me what it was for. Can anyone here help? I tried it on some wood and it basically cut much deeper!? ANy help?


Thanks
Daven
Posts: 1632
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: LASERCUT 5.3

Post by Daven »

Grade engrave allows a bit of control over the taper of the engraving - mainly used for rubber stamps where you may need a thicker base to the letter to support it.
To be honest I have never found it useful - even for stamps ;)

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
brydonuk
Posts: 22
Joined: Wed Oct 09, 2019 10:38 pm
Contact:

Re: LASERCUT 5.3

Post by brydonuk »

Ah ok, thanks 8-)
Post Reply

Who is online

Users browsing this forum: Semrush [Bot] and 6 guests