Hello,
I've just bought an A4 sheet of rubber for laser cutters from Kitronik, and as such I'd like to be able to cut and engrave it without much wastage (it wasn't cheap!).
I basically want to make myself a rubber stamp or two.
Has anyone any recommendations for power and speed to try please?
Any hints are gratefully received, thank you.
Engraving and cutting rubber
Engraving and cutting rubber
Kind regards
Kirsty x
HPC laser 3040, 40W
Kirsty x
HPC laser 3040, 40W
Re: Engraving and cutting rubber
Yes send it back
I have used it in the past and hated it to be honest - the dust seems to get everywhere! You can get a reasonable image from it but in the end I bought a UV polymer system for making stamps with.
From memory I used to use a highish scan gap setting and make two passes but can't remember the settings
Best
Dave
I have used it in the past and hated it to be honest - the dust seems to get everywhere! You can get a reasonable image from it but in the end I bought a UV polymer system for making stamps with.
From memory I used to use a highish scan gap setting and make two passes but can't remember the settings
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Re: Engraving and cutting rubber
Thank you.
I'll hopefully have a chance to try something out soon (never seem to have the time!).
Fingers crossed, but if not, I know a lady that can make one for me .
I'll hopefully have a chance to try something out soon (never seem to have the time!).
Fingers crossed, but if not, I know a lady that can make one for me .
Kind regards
Kirsty x
HPC laser 3040, 40W
Kirsty x
HPC laser 3040, 40W
Who is online
Users browsing this forum: No registered users and 9 guests