Hi,
My boss was cutting on the Ls 6840 pro 60 w and the LCD just stopped working. No noise, no flash, just stopped...
I turned everything off and gave it a while, just restarted it and still nothing, none of the buttons do anything. The red laser is still on and the water pumps still going but thats it, i cant move it in any way.
Can anybody help or suggest something i could try, please?
Thanks
Sean
LCD stopped working
Re: LCD stopped working
You can try controlling the laser from the software but sounds like a loose connector or worse the board has gone!
Best
Dave
Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC
Who is online
Users browsing this forum: Bing [Bot] and 2 guests