LaserCut 6.1 Engraving File

Moderators: HPC, Daven

Post Reply
Littlebirdsengraving
Posts: 3
Joined: Wed Apr 03, 2019 11:37 am
Contact:

LaserCut 6.1 Engraving File

Post by Littlebirdsengraving » Sun Apr 14, 2019 5:37 pm

Hi All,

New to the forum!

I previously owned a shonky Chinese Laser that after 6 months died on me (I know I know!)

I know have a LS3040 which works much better for what I make.

I design in Illustrator and then import my files into LaserCut 6.1. I just wanted to know if there are any other types of files for engraving other than using a BMP? I use a DXF file for all my cutting.

Thanks in advance,
A Newbie!

Daven
Posts: 1407
Joined: Fri Oct 15, 2010 6:44 pm
Location: Devon
Contact:

Re: LaserCut 6.1 Engraving File

Post by Daven » Sun Apr 14, 2019 6:55 pm

I do not have 6.1 but you should be able to engrave dxf as well as bmp.

In 5.1 I can also use PNG but not sure you can in 6.1

Best
Dave
Using two LS3060's and an ex 3020 user
Please note I am not employed by HPC, any advice or recomendations I give are based on my own experience and are not necessarily the same as HPC's. First point of contact on any hardware issues should be with HPC

Post Reply

Who is online

Users browsing this forum: No registered users and 1 guest